Dangerous Ladies' 3D models for Date's Evolver
Model by Jennifer Rezny (@quicksparrows)

.stl format. Pre-sliced for printing on a bed that is at least 200x200 at the base, but many pieces will fit much smaller. Finishes at about 14" from end to end.

There are two versions within; a solid version and a version you can install lights in. You can access the batteries/etc via the cartridge by pulling down on the ring; it should fit inside with pressure alone. I suggest using something small like the Lilypad coin battery holder, it's very small and easy and has a built-in switch.

The front and back attach on two 1/4" rods of the following lengths:

175mm - top bar
186mm - bottom bar

Files include:
- Photos
- .STL files

We printed ours at 0.1 mm layers. We suggest keeping a moderate infill (no lower than 15%) and walls of about 1-1.2mm.

Please do not redistribute or resell. Intended for personal use only. Commercial use must buy a new copy for each item produced.

Feel free to tag us to show us what you print and make! We love to see finished works.

Looking for a sewing pattern for this costume? Our friends got you covered! Indigo Patterns - Date Sewing Pattern