![White Mage's Bunny's Crescent Staff [3D Printed Kit] 3D Printed Kit cosplay DangerousLadies](http://dangerousladies.ca/cdn/shop/products/white-mages-bunnys-crescent-staff-3d-printed-kit-246548.jpg?v=1707156253&width=320)
![Tifa's Fairy of the Holy Spirit [3D Print Files] 3D Files cosplay DangerousLadies](http://dangerousladies.ca/cdn/shop/files/tifas-fairy-of-the-holy-spirit-3d-print-files-cosplay-846980.png?v=1727415605)
![Tifa's Fairy of the Holy Spirit [3D Print Files] 3D Files cosplay DangerousLadies](http://dangerousladies.ca/cdn/shop/files/tifas-fairy-of-the-holy-spirit-3d-print-files-cosplay-590580.png?v=1727415605)
![Tifa's Fairy of the Holy Spirit [3D Print Files] 3D Files cosplay DangerousLadies](http://dangerousladies.ca/cdn/shop/files/tifas-fairy-of-the-holy-spirit-3d-print-files-cosplay-345476.png?v=1727415605)
Dangerous Ladies' 3D models for Tifa's Fairy of the Holy Spirit accessories.
Model by Jennifer Rezny (@quicksparrows)
.stl format. Cute little bits with separate gems. The buckles print in multiple parts so you can put them on posts so they can swing, but you'll need to glue a washer or similar to the back to anchor it while keeping the back relatively flat.
Files include:
- Photos
- .STL files
We printed ours at 0.1 mm layers. We suggest keeping a moderate infill (no lower than 15%) and walls of about 1.2-1.4mm.
Please do not redistribute or resell. Intended for personal use only. Commercial use must buy a new copy for each item produced.
Feel free to tag us to show us what you print and make! We love to see finished works.
http://dangerousladies.storenvy.com
http://twitter.com/dangerousladies
http://instagram.com/thedangerousladies
Tifa's Fairy of the Holy Spirit [3D Print Files]
Dangerous Ladies' 3D models for Tifa's Fairy of the Holy Spirit accessories.
Model by Jennifer Rezny (@quicksparrows)
.stl format. Cute little bits with separate gems. The buckles print in multiple parts so you can put them on posts so they can swing, but you'll need to glue a washer or similar to the back to anchor it while keeping the back relatively flat.
Files include:
- Photos
- .STL files
We printed ours at 0.1 mm layers. We suggest keeping a moderate infill (no lower than 15%) and walls of about 1.2-1.4mm.
Please do not redistribute or resell. Intended for personal use only. Commercial use must buy a new copy for each item produced.
Feel free to tag us to show us what you print and make! We love to see finished works.
http://dangerousladies.storenvy.com
http://twitter.com/dangerousladies
http://instagram.com/thedangerousladies
Finishing Guides
Quick Finishing Guide - 3D Printed and Resin Kits
Just purchased a kit? Thanks for supporting us! Don't know where to start in assembling your 3D Print or Resin kit? We've got you covered.
The Basic Supplies for Bodyshopping 3D Prints
This guide is a great follow-along if you've purchased any Dangerous Ladies 3D printed cosplay props. This article is on the basic supplies you'll need for sanding FDM prints, with no...