Dangerous Ladies' 3D models for the Monado Replica Ex+
Model by Jennifer Rezny (@quicksparrows)

.stl format. Finishes at about 50". Pre-sliced for printing on a 20cmx20cmx30cm bed, but the tallest piece is actually only about 27.5 cm so there's a bit of wiggle room. Only two pieces go over 20cm tall.

Assembles using three dowels:
1x 45.5" long 1/2" dowel
2x 19" long 1/2 dowel

I strongly recommend using an aluminum or hollow steel rod for the 45.5" long one because it will give the piece a lot more strength. The handle is quite slim compared to the body so the extra strength can't hurt, but the dowel will work too if your prints aren't super thick/heavy. With 1.2mm walls and 0.2mm layers on most of the pieces it takes about 1.5kg of filament.

I've included multiple versions of "Sword 4-1" –– this is because there's a version with the ribbed ring, the version with the silver disc, and a version that lets you switch between the two with a set of magnets. There are visible magnet slots if you do the switching version, but being able to pop the silver disc on and off is cool.

Files include:
- Photos
- .STL files

We printed ours at 0.15-0.2 layers. We suggest keeping a moderate infill (no lower than 10%) and walls of about 1.2-1.4mm.

Please do not redistribute or resell. Intended for personal use only. Commercial use must buy a new copy for each item produced.

Feel free to tag us to show us what you print and make! We love to see finished works.