Dangerous Ladies' 3D models for DRX Kindred's Mask.
Model by Jennifer Rezny (@quicksparrows)

.stl format. Should fit on any printer, but the larger mark parts may need to fit at an angle on smaller printers.

The horns all snap together seamlessly and then pop onto a headband worn under the wig; you'll have to make sure there's slots in the wig to put the posts through. The mask can be either permanently glued or optionally magnetted to the horns so it can be removed mid-wear.

I've included two versions of the visor; one that has no lip and can just fit into the frame with the tab of your choice, or a version on a "buck" with a back lip. I suggest using the no-lip version if you're just going to paint and go, but the buck version is good if you want to make your own clear plastic lens. You can print it at a very dense infill/wall thickness and then heat form your clear plastic over it.

Files include:
- Photos
- .STL files

We printed ours at 0.15 layers. We suggest keeping a moderate infill (no lower than 10%) and walls of about 1.2-1.4mm, ideally 2mm on the joint piece.

Please do not redistribute or resell. Intended for personal use only. Commercial use must buy a new copy for each item produced.

Feel free to tag us to show us what you print and make! We love to see finished works.

http://dangerousladies.storenvy.com
http://twitter.com/dangerousladies
http://instagram.com/thedangerousladies