![White Mage's Bunny's Crescent Staff [3D Printed Kit] 3D Printed Kit cosplay DangerousLadies](http://dangerousladies.ca/cdn/shop/products/white-mages-bunnys-crescent-staff-3d-printed-kit-246548.jpg?v=1707156253&width=320)
![Sailor Moon's Moon Stick [3D Print Files] 3D Files cosplay DangerousLadies](http://dangerousladies.ca/cdn/shop/products/sailor-moons-moon-stick-3d-print-files-666706.jpg?v=1707156361)
![Sailor Moon's Moon Stick [3D Print Files] 3D Files cosplay DangerousLadies](http://dangerousladies.ca/cdn/shop/products/sailor-moons-moon-stick-3d-print-files-702344.jpg?v=1707156361)
![Sailor Moon's Moon Stick [3D Print Files] 3D Files cosplay DangerousLadies](http://dangerousladies.ca/cdn/shop/products/sailor-moons-moon-stick-3d-print-files-581289.jpg?v=1707156361)
Dangerous Ladies' 3D models for Sailor Moon's Moon Stick
Model by Jennifer Rezny (@quicksparrows)
.stl format. Wand is approximately 10.25" long. All pieces assemble on keys for easy alignment. Many small pieces print separately for easy painting.
The centre handle detail has a "dome" piece; if you can't print this in clear filament (or clear resin) you may want to omit it and simply fill the centre of the handle detail with clear resin to seal in the smaller details.
Files include:
- Photos
- .STL files
We printed ours at 0.1 layers. We suggest keeping a moderate infill (no lower than 15%) and walls of about 1.2-1.4mm.
Please do not redistribute or resell. Intended for personal use only. Commercial use must buy a new copy for each item produced.
Feel free to tag us to show us what you print and make! We love to see finished works.
Sailor Moon's Moon Stick [3D Print Files]
Dangerous Ladies' 3D models for Sailor Moon's Moon Stick
Model by Jennifer Rezny (@quicksparrows)
.stl format. Wand is approximately 10.25" long. All pieces assemble on keys for easy alignment. Many small pieces print separately for easy painting.
The centre handle detail has a "dome" piece; if you can't print this in clear filament (or clear resin) you may want to omit it and simply fill the centre of the handle detail with clear resin to seal in the smaller details.
Files include:
- Photos
- .STL files
We printed ours at 0.1 layers. We suggest keeping a moderate infill (no lower than 15%) and walls of about 1.2-1.4mm.
Please do not redistribute or resell. Intended for personal use only. Commercial use must buy a new copy for each item produced.
Feel free to tag us to show us what you print and make! We love to see finished works.
Finishing Guides
Quick Finishing Guide - 3D Printed and Resin Kits
Just purchased a kit? Thanks for supporting us! Don't know where to start in assembling your 3D Print or Resin kit? We've got you covered.
The Basic Supplies for Bodyshopping 3D Prints
This guide is a great follow-along if you've purchased any Dangerous Ladies 3D printed cosplay props. This article is on the basic supplies you'll need for sanding FDM prints, with no...